|
Product SKUs |
MBD-X7DA3-O | X7DA3 (Standard Retail Pack) |
MBD-X7DA3-B | X7DA3 (Bulk Pack) |
|
Physical Stats |
Form Factor | Extended ATX |
Dimensions | 12.075" x 13.05" (30.7cm x 33.2cm) |
|
Processor/Cache |
CPU | - Dual 771-pin LGA Sockets
- Supports up to two Intel 64-Bit Xeon processor(s) of the same type below:
- Quad-Core Intel XeonProcessor 5400/5300 sequence
- (Harpertown/Clovertown processor) up to 3.16 GHz
- Dual-Core Intel Xeon processor 5200/5100/5000 sequence (Wolfdale)
- (Woodcrest/Dempsey processor) up to 3.40 GHz
|
System Bus | 1333 / 1066 / 667 MHz system bus |
Operating System Software | - Supports 64-Bit Operating Systems
- Supports 32-Bit Operating Systems
|
|
System Memory |
Memory Capacity | - Eight 240-pin DIMM sockets
- Supports up to 32 GB 667 / 533 MHz DDR2 ECC FB-DIMM memory
- Dual branch memory bus
- Memory must be populated in pairs
- Memory Mirroring supported
|
Memory Type | 667 / 533 MHz FB-DIMM (Fully Buffered DIMM) DDR2 ECC SDRAM 72-bit, 240-pin gold-plated DIMMs |
DIMM Sizes | 512 MB, 1GB, 2GB, 4GB |
Memory Voltage | |
Error Detection | - Corrects single-bit errors
- Detects double-bit errors (using ECC memory)
- Supports Intel x4 and x8 Single Device Data Correction (SDDC)
|
|
On-Board Devices |
Chipset | - Intel 5000X (GreenCreek) chipset
- MCH + PXH-V + ESB2
|
SAS | - Adaptec AIC-9410W Serial-Attached SCSI (SAS) Controller
- SAS Dual-Channel (internal)
- Each SAS channel supports up to 4 SAS / SATA drives for a total of up to 8 SAS or SATA hard drives
- Host RAID 0, 1, & 10 support
|
SATA | - Intel ESB2 SATA-2 controller
- RAID 0, 1, 5, 10 support (Windows Only)
- RAID 0, 1, 10 support (Linux)
|
RAID | - Support for Zero-Channel RAID
- RAID 0, 1, 5, 10
- Optional: (card NOT included)
|
IPMI | - Support for Intelligent Platform Management Interface v.2.0
- 200-pin IPMI slot (SIMLP)
- (Optional: AOC-SIMLP-B)
- (Optional: AOC-SIMLP-3) with 3rd LAN support
- NOTE: KVM-over-LAN not supported - there is no DVO signal to the IPMI slot
|
Network Controllers | - Intel 82563EB Dual-Port Gigabit Ethernet Controller
- Supports 10BASE-T, 100BASE-TX, and 1000BASE-T; RJ45 output
- Intel I/OAT support for fast, scaleable, and reliable networking
|
Super I/O | Winbond 83627HG chip |
|
Input / Output |
Serial ATA | - Six Serial ATA ports
- Six SATA hard drives supported
|
IDE | - Single EIDE channel supports up to two UDMA IDE devices(IDE-M, IDE-S) including CF card
- Supports UDMA Mode 5, PIO Mode 4, and ATA/100
- Compact Flash (40-pin connector, IDE 1, single channel) slot
|
Floppy | 1x Floppy controller; 1.44 MB, 2.88 MB |
LAN | 2x RJ45 LAN ports |
USB | - 4x USB rear ports
- 2x USB internal header
- 6 total USB ports, 2.0 Compliant / 1.1 Compliant
|
Audio | AC97 Audio |
Keyboard / Mouse | PS/2 keyboard and mouse ports |
Serial Port / Header | - 1x Fast UART 16550 serial port
- 1x Fast UART 16550 serial header
|
Parallel Port | 1x ECP / EEP parallel port |
|
Chassis ( Optimized for X7DA3 ) |
2U Chassis | - CSE-825TQ-R700LPV
- CSE-825TQ-560LPV
- CSE-823T-550LP
|
3U Chassis | - CSE-836E1-R800
- CSE-836E2-R800
- CSE-833T-550 (SIMLC Support only)
- CSE-833T-R760 (SIMLC Support only)
- CSE-933E1-R760
- CSE-933E2-R760
- CSE-933T-R760
- CSE-933TQ-R760
|
Tower / 4 U Rackmount | CSE-743T-645 |
Important Chassis Notes | To ensure system stability, a 500W (minimum) ATX power supply [4-pin (+12V), 8-pin (+12V) and 24-pin are required] |
|
Expansion Slots |
PCI-Express | - 1x (x16) PCI-e slot
- 1x (x4) PCI-e (using x16) slot
|
PCI-X | - 2x 64-bit 133/100MHz PCI-X (3.3V) slots
- 1x 64-bit 100MHz PCI-X (3.3V) slot
|
PCI | 1x 32-bit 33MHz PCI (5V) slot |
|
System BIOS |
BIOS Type | 8Mb Flash EEPROM with Phoenix BIOS |
BIOS Features | - Plug and Play (PnP)
- SMBIOS 2.3
- DMI 2.3
- PCI 2.2
- ACPI 1.0
- PCI-X 1.0
- USB Keyboard support
- Hardware BIOS Virus protection
|
|
Management |
Software | - Optional IPMI (Intelligent Platform Management Interface) v2.0
- SuperDoctor® III
- Watch Dog
- NMI
|
Power Configurations | - ACPI Power Management
- Main Switch Override Mechanism
- Wake-On-Ring (WOR) header
- Wake-On-LAN (WOL) header
- Keyboard wakeup from soft-off
- CPU Fan Auto-off in Sleep Mode
- Power-on mode for AC power recovery
- Internal/External modem remote ring-on
- Suspend to RAM (STR)
|
|
PC Health Monitoring |
Voltage | - Monitors for CPU Cores, +1.8V, +3.3V, +5V, -12V & +5V Standby, VBAT
- CPU core 5-Phase-switching voltage regulator with auto-sense from 0.8375V-1.60V
|
FAN | - Total of eight 4-pin fans
- 8x fans with status monitoring
- Status monitor for speed control
- Status monitor for on/off control
- Support for 3-pins (w/o speed control)
- Low noise fan speed control
|
Temperature | - Monitoring for CPU and chassis environment
- CPU thermal trip support
- Thermal Control for 8x Fan Connectors
- PSU I²C temperature sensing logic
- Thermal Monitor 2 (TM2) support
- PECI
|
LED | - CPU / System Overheat LED
- Supsend-State Indicator LED
- +5 V Standby Alert LED
|
Other Features | - Chassis intrusion detection
- Chassis intrusion header
- SDDC Support
|
|
Operating Environment / Compliance |
RoHS | RoHS Compliant 6/6, Pb Free |
Environmental Specifications | - Operating Temperature: 10° to 35 °C (50° to 95 °F)
- Non-operating temperature: -40° to 70 °C (-40° to 158 °F)
- Operating relative humidity: 8% to 90% (non-condensing)
- Non-operating relative humidity: 5 to 95% (non-condensing)
|
|
OS compatibility |
Please see our OS Compatibility Chart |
|
Regulatory |
FCC | Class B |