| |
Product SKUs |
| MBD-X6DHE-XB-O | X6DHE-XB (Standard Retail Pack) |
| MBD-X6DHE-XB-B | X6DHE-XB (Bulk Pack) |
| |
Physical Stats |
| Form Factor | Extended ATX |
| Dimensions | 12" x 13.05" (30.5cm x 33.2cm) |
| |
Processor/Cache |
| CPU | - Dual 604-pin FC-mPGA4 Sockets
- Supports up to two Intel 64-Bit Xeon processor(s) of the same type below:
- Xeon (Nocona) CPU with 1 MB L2 Integrated Advanced Transfer Cache, up to 3.60 GHz
- Xeon (Irwindale) CPU with 2 MB L2 Integrated Advanced Transfer Cache, up to 3.80 GHz
- Xeon LV (Low Voltage) CPU, up to 2.8 GHz
|
| System Bus | 800 MHz system bus |
| Operating System Software | - Supports 64-Bit Operating Systems
- Supports 32-Bit Operating Systems
- OS compatibility chart
|
| |
System Memory |
| Memory Capacity | - Eight 184-pin DIMM sockets
- Supports up to 16 GB DDR 333 MHz memory or
- Supports up to 32 GB DDR 266MHz memory
- Dual channel memory bus
|
| Memory Type | DDR333/266 MHz buffered (registered) ECC SDRAM 72-bit, 184-pin gold-plated DIMMs |
| DIMM Sizes | 512 MB, 1GB, 2GB, 4GB** |
| Memory Voltage | 2.5 V only |
| Error Detection | - Corrects single-bit errors
- Detects double-bit errors (using ECC memory)
- Supports Intel x4 Single Device Data Correction (SDDC)
|
| |
On-Board Devices |
| Chipset | - Intel E7520 chipset
- MCH + ICH5R + PXH + BCM5721
|
| SATA | - ICH5R SATA Controller
- RAID 0, 1, JBOD support
|
| IPMI | - Support for Intelligent Platform Management Interface v.2.0
- (Optional: AOC-IPMI20-E)
|
| Network Controllers | - 2x Broadcom BCM5721 Gigabit Ethernet Controller
- Supports 10BASE-T, 100BASE-TX, and 1000BASE-T; RJ45 output
|
| Graphics | ATI Rage XL SVGA PCI video controller with 8 MB of video memory |
| Super I/O | Winbond 83627HF chip |
| |
Input / Output |
| Serial ATA | - Two Serial ATA ports
- Two SATA hard drives supported
|
| IDE | - Dual EIDE channels support up to four UDMA / IDE devices
- Supports ATA/100
|
| Floppy | 1x Floppy controller; 1.44 MB support |
| LAN | 2x RJ45 LAN ports |
| USB | - 2x USB rear ports
- 1x USB internal dual header supports up to 2 USB ports
- 1x USB internal header supports single USB port
- USB 2.0 compliant
|
| VGA | 1x VGA port |
| Keyboard / Mouse | PS/2 keyboard and mouse ports |
| Serial Ports | 1 Fast UART 16550 serial port and 1 serial header |
| |
Chassis ( Optimized for X6DHE-XB2 ) |
| 2U | - SC823i-R500RC
- SC823i-550LP
|
| 3U | |
| Tower / 4 U Rackmount | - SC743i-R760
- SC743i-650
- SC742i-600
- SC742i-550
- SC742i-500
- SC742i-420
- SC942i-600
|
| Important Chassis Notes | - To ensure system stability, a 420W (minimum) ATX power supply [4-pin (+12V), 8-pin (+12V) and 24-pin are required]
- Chassis must have CPU mounting holes required for 800MHz FSB CPUs with this serverboard.
|
| |
Expansion Slots |
| PCI-Express | 1 (x4) signal on a (x8) slot |
| PCI-X | - 2x 64-bit 133MHz PCI-X (3.3V) slots
- 4x 64-bit 100MHz PCI-X (3.3V) slots
|
| |
System BIOS |
| BIOS Type | 8Mb Flash EEPROM with Phoenix BIOS |
| BIOS Features | - Plug and Play (PnP)
- SMBIOS 2.3
- DMI 2.3
- ACPI 1.0
- USB Keyboard support
|
| |
Management |
| Software | - Optional IPMI (Intelligent Platform Management Interface) 2.0
- SuperDoctor® III
- Watch Dog
- NMI
|
| Power Configurations | - ACPI/APM Power Management
- Main Switch Override Mechanism
- Wake-On-Ring (WOR) header
- Wake-On-LAN (WOL) header
- Power-on mode control for AC power loss recovery
|
| |
PC Health Monitoring |
| Voltage | - Monitors for CPU Cores(+1.8V, +3.3V, +5V, ±12V, +3.3V Standby, +5V Standby, & VBAT)
- CPU Core 4-Phase-switching voltage regulator with auto-sense from 0.86V-1.63V
|
| FAN | - Total of four 4-pin + four 3-pin fan headers
- 8x fans with status monitoring
- Status monitor for speed control
- Status monitor with software on/off control
- Low noise fan speed control
- Pulse Width Modulated (PWM) fan connector
|
| Temperature | - Monitoring for CPU, chassis, environment
- CPU thermal trip support
- Thermal Control for 8x Fan Connectors
- I²C temperature sensing logic
- Thermal Monitor 2 (TM2) Support
|
| LED | - CPU / System Overheat LED
- Supsend-State Indicator LED
|
| Other Features | - Chassis intrusion detection
- Chassis intrusion header
- SDDC
|
| |
OS compatibility |
| Please see our OS Compatibility Chart |