| |
Product SKUs |
| SYS-5025M-i | SuperServer 5025M-i (Beige) |
| SYS-5025M-iB | SuperServer 5025M-iB (Black) |
| |
Motherboard |
| Super PDSME |
| |
Processor/Cache |
| CPU | - Single LGA775 ZIF Socket
- Supports an Intel Pentium D (Smithfield Dual Core) processor
- Supports an Intel Pentium Extreme Edition processor
- Supports an Intel Pentium 4 (Prescott) processor
- Supports an Intel Pentium 4 Extreme Edition processor
- Supports an Intel Celeron D processor
- Hyper-Threading (HT) capable
- 1MB L2 Cache
|
| System Bus | 1066 / 800 / 533 MHz system bus |
| |
System Memory |
| Memory Capacity | - Four 240-pin DIMM sockets
- Supports up to 8 GB of unbuffered, ECC / non-ECC DDR2 667/533/400 MHz memory (Single / Dual Channel)
|
| Memory Type | DDR2 667/533/400 MHz unbuffered, ECC / non-ECC SDRAM, 240-pin gold-plated DIMMs |
| DIMM Sizes | 256 MB, 512 MB, 1 GB, 2 GB |
| Memory Voltage | 1.8 V only |
| |
On-Board Devices |
| Chipset | - Intel E7230 (Mukilteo) chipset
- ICH7R + PXH-V + Intel 82573V
|
| SATA | - Intel ICH7R SATA controller built-in
- RAID 0, 1, 5, 10
|
| IPMI | - 2U, 3U, 4U support for Intelligent Platform Management Interface v.2.0, Low-Profile (Optional: LPIPMI)
- RMM (Remote Management Module)
- (Card not included)
- 3rd LAN Optional
|
| Network Controllers | - Dual-port Intel 82573V Gigabit PCI-Express Ethernet (Tekoa)
- Supports 1000BASE-T, RJ45 output
|
| VGA | On-board ATI Rage XL (8MB) graphics |
| Super I/O | Winbond 83627EHF chip |
| Clock Generator | CK410 |
| |
Input / Output |
| Floppy | 1x Floppy controller; 1.44 MB |
| LAN | 1x RJ45 LAN port |
| USB | - 6x USB 2.0 compliant / 1.1 compatible
- 2 rear ports, 4 internal headers
- 2 in front (FUCI), 2 in rear
|
| VGA | 1x VGA port ( only) |
| Audio | 1x Line In / Line Out / Microphone port |
| Keyboard / Mouse | PS/2 keyboard and mouse ports |
| Serial Port / Header | - 1x Fast UART 16550 serial port
- 1x Fast UART 16550 serial header
|
| Parallel Port | 1x ECP / EEP Parallel Port |
| |
System BIOS |
| BIOS Type | 8Mb Flash EEPROM with Phoenix BIOS |
| BIOS Features | - Plug and Play (PnP)
- DMI 2.3 support
- PCI 2.2
- ACPI 1.0
- Hardware BIOS Virus protection
- SMBIOS 2.3
- USB Keyboard support
|
| |
Chassis |
| Form Factor | 2U Rackmount |
| Model | SC822i-400LP |
| |
Dimensions |
| Height | 3.5" (89mm) |
| Width | 16.8" (426 mm) |
| Depth | 25.6" (650mm) |
| Gross Weight | 49 lbs (22.3kg) |
| Available Colors | Beige, Black |
| |
Front Panel |
| Buttons | - Power On/Off button
- System Reset button
|
| LEDs | - Power LED
- Hard drive activity LED
- 2x Network activity LEDs
- System Overheat / Fan Failure LED
|
| Ports | N/A |
| |
Expansion Slots |
| PCI-Express | 1x (x4) PCI-e slot |
| PCI-X | - 2x 64-bit 133MHz PCI-X (3.3V) slots
- 2x 64-bit 100MHz PCI-X (3.3V) slots
|
| |
Drive Bays |
| Fixed | 2x Fixed IDE drive carriers (each carrier supports up to 3 hard disk drives) |
| Peripheral Bay(s) | 1x 5.25" full-height peripheral bay |
| |
Peripheral Drives |
| Floppy | Panasonic 3.5" 1.44 MB Floppy Drive |
| CD-ROM | TEAC slim 24x CD-ROM drive |
| |
System Cooling |
| Fans | 4x 80 mm 3400 RPM fans |
| |
Power Supply |
| 2U 400W AC power supply with PFC[ 24-pin, (8-pin, 4-pin)=12V) ] |
| AC Voltage | 100 - 240V, 47 - 63Hz, 7 A |
| DC Output | 12V + 5V + 3.3V @ 385W |
| +5 V | 33.0 A |
| +5 V standby | 2.0 A |
| -5V | 0.8 A |
| +12 V | 25.0 A |
| -12 V | 1.0 A |
| +3.3 V | 28.0 A |
| |
PC Health Monitoring |
| CPU | - Monitors for CPU Cores (+1.8V, +3.3V, +5, 12V, +3.3V/+5V Standby)
- CPU core 4-Phase-switching voltage regulator with auto-sense from 0.8375V-1.6000V
- Adjustable CPU clock frequency ratio settings (via BIOS)
|
| FAN | - Total of five 4-pin fan headers
- 5x fans with tachometer monitoring
- Status Monitor with firmware / software speed control
- Status monitor for on/off control
- Supports 3-pin fans (with speed control)
- Low noise fan speed control
- Pulse Width Modulated (PWM) fan connector
|
| Temperature | - Monitoring for CPU and chassis environment
- CPU thermal trip support
- Thermal Monitor 2 (TM2) Support
|
| LED | - CPU / System Overheat LED
- +5 V standby alert LED
- Supsend-State Indicator LED
|
| Other Features | - Chassis intrusion detection
- Chassis intrusion header
|
0 Articoli
