| |
Product SKUs |
| SYS-5015M-T+ | SuperServer 5015M-T+B(Beige) |
| SYS-5015M-T+B | SuperServer 5015M-T+B (Black) |
| |
Motherboard |
| Super PDSMi+ |
| |
Processor/Cache |
| CPU | - Single LGA775 ZIF Socket
- Supports a Quad-Core Intel Xeon 3200 series processor
- Supports a Dual-Core Intel Xeon 3000 series processor
- Supports a Quad-Core Intel Core 2 Extreme series processor
- Supports an Intel Core2 Quad series processor
- Supports an Intel Core2 Duo series processor
- Supports an Intel Pentium processor E2000 series
- Supports a Dual-Core Intel Pentium D processor
- Supports an Intel Pentium Extreme Edition processor
- Supports an Intel Pentium 4 processor
- Supports an Intel Celeron processor E1000 series
- Supports an Intel Celeron processor 400 series
- NOTE: This board DOES NOT support Q9000, E8000, E7000, E5000 series or 45 nm processor
|
| System Bus | 1066 / 800 / 533 MHz system bus |
| |
System Memory |
| Memory Capacity | - Four 240-pin DIMM sockets
- Supports up to 8 GB of memory (Single / Dual Channel)
|
| Memory Type | DDR2 667/533 MHz unbuffered, ECC / non-ECC SDRAM, 240-pin gold-plated DIMMs |
| DIMM Sizes | 256 MB, 512 MB, 1 GB, 2 GB |
| Memory Voltage | 1.8 V only |
| |
On-Board Devices |
| Chipset | - Intel 3000 (Mukilteo-2) chipset
- ICH7R + PXH-V + Intel 82573V + Intel 82573L
|
| Serial ATA | - Intel ICH7R SATA controller built-in
- RAID 0, 1, 5, 10 support (Windows Only)
- RAID 0, 1, 10 support (Linux)
|
| IPMI | - Support for Intelligent Platform Management Interface v.2.0
- (Optional: AOC-IPMI20-E)
|
| Network Controllers | - 1x Intel 82573V Gigabit PCI-Express Ethernet
- 1x Intel 82573L Gigabit PCI-Express Ethernet
- Supports 10Base-T, 100Base-TX, 1000BASE-T, RJ45 output
|
| VGA | On-board ATI ES1000 16MB graphics |
| Super I/O | Winbond 83627EHG chip |
| Clock Generator | CK410 |
| |
Expansion Slots |
| Universal Slot | - 1x 64-bit PCI-X 133MHz Slot (via Riser Card) OR
- 1x (x8) PCI-Express Slot (via Riser Card) - Optional
|
| |
Input / Output |
| Serial ATA | - Four SATA ports (3 Gb/s performance)
- Four SATA hard drives supported
|
| IDE | - One EIDE channel supports up to two UDMA/IDE devices
- IDE Master / Slave 2 ports
- Supports UDMA Mode 5, PIO Mode 4, and ATA/100
- White Connector for Compact Flash (CF, 40-pin IDE connector) card only
|
| LAN | 2x RJ45 LAN ports |
| USB | - Up to 6x USB 2.0 compliant / 1.1 compatible ports
- 4x Internal USB headers
- 2x rear USB ports
|
| VGA | 1x VGA Port |
| Keyboard / Mouse | PS/2 keyboard and mouse ports |
| Serial Ports | - 1x Fast UART 16550 serial port
- 1x Header
|
| Parallel Port | 1x ECP / EEP Parallel Header |
| |
Chassis |
| Form Factor | 1U Rackmount |
| Model | SC811T-300 |
| |
Dimensions |
| Height | 1.7" (43 mm) |
| Width | 16.8" (426 mm) |
| Depth | 22.6" (574 mm) |
| Gross Weight | 35 lbs (15.9 kg) |
| Available Colors | Beige, Black |
| |
Front Panel |
| Buttons | - Power On/Off button
- System Reset button
|
| LEDs | - Power LED
- Hard drive activity LED
- 2x Network activity LEDs
- System Overheat / Fan Failure LED
|
| Ports | None |
| |
Drive Bays |
| Hot-Swap | 2x 3.5"SATA Hot-swap drive bays |
| |
System Cooling |
| Fans | 3x 3-pin Counter-rotating Cooling Fans |
| |
Power Supply |
| Fixed 300 W AC power supply module with PFC [ 24-pin, (4-pin = 12 V), 4-pin HDD ] |
| AC Voltage | 100 - 240V, 60-50Hz, 5 A |
| DC Output | 5V + 3.3V @ 100W |
| +5 V | 25 A |
| +5 V standby | 2.0 A |
| +12 V | 24.0 A (Max) |
| -12 V | 1.0 A |
| +3.3 V | 15.0 A |
| |
PC Health Monitoring |
| CPU | - Monitors for CPU Cores (+1.8V, +3.3V, +5, 12V, +3.3V/+5V Standby, VBAT)
- CPU core 4-Phase-switching voltage regulator with auto-sense from 0.8375V-1.6000V
- Adjustable CPU clock frequency ratio
|
| FAN | - Fan Speed Control
- Total of six 4-pin fan headers
- 6x fans with tachometer monitoring
- Status Monitor with firmware speed control
- Low noise fan speed control
- Status monitor for on/off control
- Supports 3-pin fans (without speed control)
- Pulse Width Modulated (PWM) fan connector
|
| Temperature | - Monitoring for CPU and chassis environment
- CPU thermal trip support
- Thermal Monitor 2 (TM2) Support
|
| LED | - CPU / System Overheat LED
- +5 V Standby Alert LED
- Supsend-State Indicator LED
|
| Other Features | - Chassis Intrusion Detection
- Chassis Intrusion Header
|
| |
System BIOS |
| BIOS Type | 8Mb Flash EEPROM with Phoenix BIOS |
| BIOS Features | - Plug and Play (PnP)
- DMI 2.3 support
- PCI 2.2
- ACPI 1.0
- USB Keyboard support
- SMBIOS 2.3
|
0 Articoli
